The square tube automatic polishing machine can sand, wire and polish the surface of copper, iron, aluminum, stainless steel and other shapes.
The key to the polishing operation of the polishing machine is to try to obtain the maximum polishing rate so as to remove the damage layer generated during polishing as soon as possible. At the same time, the polishing damage layer should not affect the final tissue, that is, it will not cause false tissue. The former requires the use of coarser abrasives to ensure a greater polishing speed and density to remove the dull damage layer. But the polishing damage layer is also deeper; the latter requires the use of the finest materials to make the polishing damage layer shallower, but the polishing rate is low. The best way to solve this contradiction is to divide the polishing into two stages. The purpose of rough polishing is to remove the polishing damage layer. This stage should have the maximum polishing rate. The surface damage formed by rough polishing is a secondary consideration, but it should also be as small as possible; followed by fine polishing or final polishing), Its purpose is to remove the surface damage caused by rough polishing and minimize polishing damage. The operation of the automatic polishing machine is relatively simple, and the operator only needs to place the objects to be polished on the corresponding fixture in advance. Fix the jig on the table of the automatic polisher. Start the automatic polishing machine, the automatic polishing machine completes the polishing work within the set time, and stops automatically, just remove the object from the worktable. Before polishing the automatic polishing machine, it is necessary to adjust the distance between the polishing head and the work surface. To achieve the best contact effect, throw the best effect. Hand waxing can be used during polishing to reduce machine cost
Post time: May-19-2022